Re: Save your drivers seat bolster.
|
|
I repaired my front seats bolsters then put tight sheep skin seat covers over them, i make sure when jumping out of my xr not to put too much weight on that right side bolster.
I also taped up the frames with foam tape iirc where they were poking out of the torn bolster cover fabric lessening the sharp edge of the seat frame there, giving my good unripped seat covers a way easier time now.
My bolsters are still good & going strong, looks way better than what they were lol!
cheers, Maka
__________________
Ford AU Series Magazine Scans Here - www.fordforums.com.au/photos/index.php?cat=2792
Proud owner of a optioned keeper S1 Tickford Falcon AU XR6 VCT - "it's actually a better-balanced car than the XR8, goes almost as hard and uses about two-thirds of the fuel" (Drive.com 2007)
|