Some of the accessories.
It comes with 2 work heads plus a vice. The work heads allow rotation the tool you are making as well as being able to position the workhead into just about any angle
The second workhead is powered
I need to find some tool holders for these. The have a #50 taper on one end and a MT5 on the other end. This stuff is mostly missing apart from a MT5 to MT3 adapter and a #50 to #40 adapter. You can also grind between centres on this setup, but again the parts for this are missing, so is the chuck.
I am hoping to adapt a NT50 tool holder to fit into the #50, but will need to do some more research.
I also thing I need to strip these heads down. One was a bit hard to turn as it seemed to have run dry. I will probably use that opportunity to see if I can retro fit a shaft that suits more modern tool holders.