|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
05-05-2008, 08:37 PM
|
#1 | ||
|
Starter Motor
Join Date: May 2008
Posts: 10
|
Hi everyone, just bought a AUIII XR8 and have replaced the rear shock mounts as they were shot. The car has been lowered by the previous owner and all I've done is removed / replaced everything as I found it, (with the new mounts). The problem I'm having is that no matter how tight a do up the shock nut there is still movement when I bounce the car as the thread on the sock is not long enough. When I took the top shock washer off, the 'cup' of the washer was facing up, should the 'cup' be facing down to allow the correct tightening?
|
||
|
|
| Thread Tools | |
| Display Modes | |
|
|
AUIII IRS shock mounts
Threaded Mode