|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| Drag Racing Discuss Drag Racing here be it dirt or tarmac. Sponsored by Sydney Dragway. |
|
|
Thread Tools | Display Modes |
21-02-2011, 08:39 PM
|
#1 | ||
Join Date: Nov 2009
Location: Brisbane
Posts: 136
|
Bought a new intake manifold for BA 4.0
On closer inspection we found a deep cast fault in it that had been camouflaged with a dob of thick alloy colored paint. The fault runs down pretty far just under the surface & pops out in certain areas. Do you think it will crack after it heats up & cools down a few times? Should i try to get it replaced? It is in the machined No2 bank injector recess. My mechanic says that the injector may eventually leak there. 
__________________
Making Others Feel Inferior Since 1986 Last edited by BongoKongo; 21-02-2011 at 08:52 PM. |
||
|
|
Problem with New intake manifold/runners
Threaded Mode