|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
07-01-2012, 06:39 PM
|
#1 | ||
|
not here much anymore
Join Date: Dec 2004
Location: Sthn NSW
Posts: 22,918
|
After some confirmation, I am about to order an intake pipe (doing it cheap through work just to see how I go with it) and I am planning on getting a 3" ID pipe with a 60deg bend, and a couple of 3" silicone flexi joiners.
I have 65mm TB and also the G&D Airbox setup but the bit that concerns me is the bend, is 60deg the right angle for our intakes? If someone could confirm please.
__________________
2024 F150 XLT
|
||
|
|
V8 Intake Pipes
Threaded Mode