AU Tickford Caliper - Problem Solved

[Bucknaked]

Since changing my rotors to DBA 4000's and Ferodo Performance pads, I've had an ongoing problem with the caliper and the bounce in reverse. It's been covered in threads before. Anyway, I ordered a kit from John at cebco on advice from Sylox. Same problem he had. Sylox replaced the pin running through the caliper and this solved his problem. I did this and it made no difference. Logic would tell me to call John back for further info, but i didn't) In the kit came 4 new clips, washers and some new circlips. There were also rubber bushes. No idea what the bushes were for, i took the car in for a service and had the dealer look at it. None of the technicians knew what they were for. So I decided after months of this issue, i'd put the car on stands and try to figure out a solution. Orginally when i did the pins I looked at the clips on the pads and they were near new. So I never bothered to change them as they were as firm and had as much movememnt as the new ones.

So anyway, i thought I'd change the clips and look over the rubber bush to see where it goes. See if i can work it out. Then the Mrs comes out to have a look at the calipers and see how muck painting they will need and says "That rubber bush is the same shape as that clip. Does that go inside it?" Whadda ya know. It does. Then i thought about it some more and the reason why ford never had an idea what the bush was for was because the genuine pads are the correct size. They don't move. Aftermarket could be smaller so the bush fills the gap in the clip to take up the slack when in reverse. Must be an aftermarket thing. The old clips never had the bush. So I replace both clips on each side with bushes inside, roll the car out of the garage and chuck it in reverse, no more caliper movement.

Anyway, so today I learn't something new. I'm no expert on brakes, but I am a little more wiser. And thankfully Julie came out at the right time. Sometimes the most obvious thing, is actually the answer.