|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
23-07-2022, 09:05 PM
|
#1 | ||
|
Starter Motor
Join Date: Jun 2022
Posts: 9
|
Anyone taken on the task of replacing a PCV valve on an 08 focus 2.0L Duratec engine?
Took my throttle body off today to clean it due to idel issues & was surprised to see what i saw- The throttle body was thick on the inside with engine oil. Upon looking into the intake manifold i literally have a puddle of engine oil in there. I am looking to remove the intake manifold, replace the gaskets and the PCV Valve although struggling to find some where to buy the valve from. Im not sure if the US model focus use the same valve as the Japanese/ Australian model vehicles. Anyone have to purchase this before in AUS, or would going to ford be my best bet? |
||
|
|
2008 Ford Focus LT 2.0L PCV Valve
Threaded Mode