![]() |
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 | ||
Starter Motor
Join Date: Jan 2015
Posts: 12
|
Replaced the cam shaft sycnroniser in my AU falcon yesterday (V8 windsor).
Is there any easy way I can tell if I did it correctly? Car seems to be running fine and sounding the same as it always has, minus the cam shaft sync whinging when I put my foot down. I was thinking of getting a mechanic to have a look when I take it in for a service. I'm a little worried because it wasn't until after I replaced it that I realised that I needed to have the engine on the compression stroke when on TDC and that it could be 360 out. Anyways it seems I may just of gotten lucky, but I was reading that just a minor degree out from TDC can have consequences. I took it for a good run on the freeway with no dramas, around 150kms. |
||
![]() |
![]() ![]() |
![]() |
#2 | ||
Starter Motor
Join Date: Jan 2015
Posts: 12
|
Well, she's still running fine
![]() |
||
![]() |
![]() ![]() |
![]() |
#3 | ||
Regular Member
Join Date: Jun 2010
Posts: 122
|
|
||
![]() |
![]() ![]() |
![]() |
#4 | ||
FF.Com.Au Hardcore
Join Date: Jan 2007
Location: Cairns
Posts: 534
|
Mine runs fine after I replaced my synchroniser too ... apart from the hesitation from a standing start. Might have to pull it out and start again
__________________
AU2 XR6 VCT...
Powered by Vortech ![]() ![]() |
||
![]() |
![]() ![]() |
![]() |
#5 | ||
Starter Motor
Join Date: Jan 2015
Posts: 12
|
Mine also has hesitation but I never really noticed it until I read it on here. Regardless, it was doing it long before I replaced the cam shaft sync.
|
||
![]() |
![]() ![]() |
![]() |
#6 | ||
Regular Member
Join Date: May 2010
Location: western sydney
Posts: 350
|
Have a look in my build thread I have a few pictures and some discussion on it.
http://www.fordforums.com.au/showthread.php?t=11429552
__________________
AU11 xr8 manual |
||
![]() |
![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|