![]() |
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 | ||
FF.Com.Au Hardcore
Join Date: Dec 2007
Location: Ballarat
Posts: 2,126
|
Hi all, need to replace a few parts on an au 5.0 and can't seem to find them anywhere. Any help would be appreciated. I need:
Fuel pressure reg to intake manifold hose (little red plastic hose) Steel heater pipes that run along manifold Pcv grommet in intake manifold Moulded hose from pcv to intake Plastic line from oil fill spout to intake manifold Thanks |
||
![]() |
![]() ![]() |
![]() |
#2 | ||
FF.Com.Au Hardcore
Join Date: Aug 2009
Posts: 2,285
|
What's the VIN?
|
||
![]() |
![]() ![]() |
![]() |
#3 | ||
FF.Com.Au Hardcore
Join Date: Dec 2007
Location: Ballarat
Posts: 2,126
|
6fpaaajglwxy57888
|
||
![]() |
![]() ![]() |
![]() |
#4 | ||
Ford T3 Partsologist
Join Date: May 2010
Location: Morawa W.A.
Posts: 988
|
G’day I can help with the steel heater pipe New Reproduction $415.00 plus post
https://www.ebay.com.au/itm/194372563859 ***
__________________
![]() 2002 Blueprint T3 TE50 Manual Koni Suspension # 161 ![]() ![]() T-Series Club of Australia - www.tseriesclub.org ![]() ![]() Last edited by Dingo; 06-11-2021 at 11:40 PM. |
||
![]() |
![]() ![]() |
![]() |
#5 | ||
FF.Com.Au Hardcore
Join Date: Dec 2007
Location: Ballarat
Posts: 2,126
|
Thanks but for that price I'll just put the sender in the intake and run rubber the whole way
|
||
![]() |
![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|