Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 06-02-2008, 11:50 PM   #1
kcej
2mny projects 2 lttl time
 
Join Date: Oct 2007
Location: Bald Hills Qld
Posts: 338
Default Help Please_AU Engine Diagnostics

Tried "the workshop" but was ignored bigtime. Shoulda tried here first

I have an AU3 that I bought damaged.
Seemed to idle fine, start easy, but had a flat spot on acceleration
In the two weeks I've been driving it daily, the miss has gotten worse. Also, it now takes four or five seconds and a pump to start where before it was instant, with no need for pedal
Guy at work blamed dirty injectors, but before I pull em out, thought I'd ask here.
I have a complete car that I can go the "swap a part at a time" elimination route with, but where to start, and in what order, considering both
1..likelihood as a cause
2..work involved in swapover

injectors?....coil pack?....some of the sensors?

Help please.......Keith

kcej is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 12:17 AM   #2
BeStRaFe
lpg = big boom!
 
BeStRaFe's Avatar
 
Join Date: Oct 2006
Posts: 1,377
Default

check the leads...
__________________
BF Futura Dedicated E-GAS w/Ghia bling
Project: 86 ZL Fairlane, Red, Sunroof, 310,000KM
BeStRaFe is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 07:50 AM   #3
FGII-XR6
FF.Com.Au Hardcore
 
FGII-XR6's Avatar
 
Join Date: Aug 2006
Location: Salamander Bay
Posts: 5,427
Default

leads coil pack and plugs are a good start
FGII-XR6 is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 08:20 AM   #4
kcej
2mny projects 2 lttl time
 
Join Date: Oct 2007
Location: Bald Hills Qld
Posts: 338
Default

thanks guys I'll start there
kcej is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 08:20 AM   #5
mik
FF.Com.Au Hardcore
 
mik's Avatar
 
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
Default

i`d be changing the fuel filter as well just in case.
mik is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 10:13 AM   #6
EvilChief
Boost Addict
 
Join Date: Jan 2005
Location: North Brisbane
Posts: 1,151
Default

Quote:
Originally Posted by au3xr6
leads coil pack and plugs are a good start

spot on

buy urself a little spark tester for about 15 bucks, with this you will be able to test the strength of the coils, if u feel fancy remove coilpack and test your primary and secondary circuits for resistance. a coil with less resistance on teh secondary winding can indicate an internal short.
also measure the resistance of all spark plug leads with an ohm (multi) meter, if they are all under 15kohm

look at spark plugs, is the gap right, correct heat range, is the electrode burnt, are they sutty, etc

once all ur ignition components check out fine, check for fuel pressure (both at idle and under load, if fuel pressure drops off you may have a dying fuel pump, check fuel filter on much crap is in it, last but not least fuel pressure regulator, use a pair of pliers to clamp the return line for the fuelrail and do the fuel pressure test again.
__________________
N12 Pulsar - sold
Gen1 Liberty Turbo - sold
VP Commodore Turbo - sold
LN65 Hilux Turbo - sold
EL31 Corolla Turbo - sold
Ford AU Ute Turbo - sold
Ford AU XR8 Sedan - 5.4l V8 Turbo (in the build)
Ford BA XR6T Ute - daily driver
Ford FG XR6T Sedan - cruiser

do you see a general trend? I DO

Can't live with it, can't live without it!
EvilChief is offline   Reply With Quote Multi-Quote with this Post
Old 07-02-2008, 10:53 AM   #7
aye you
The Origional, The Best
 
aye you's Avatar
 
Join Date: Dec 2006
Location: Darwin, NT
Posts: 709
Default

my moneys on the leads and coil pack
__________________
Current Mods
2.5" Red Back Exhaust | C2R Grill | Brumby Front Bar & Driving Lights | 18" Optic Blacks | Tickford Intake | Blue Momo Shifter Knob & Wheel | BA Scuff Plates with Ford Metal Inserts
Future Mods
Lowerage on KingSprings Lows | Engine...Period | Sounds System

I Use And Recommend F1 Tyres And Wheels On The Gold Coast

Proud Supporter of Beat The Heat (NT)
aye you is offline   Reply With Quote Multi-Quote with this Post
Old 08-02-2008, 11:33 PM   #8
kcej
2mny projects 2 lttl time
 
Join Date: Oct 2007
Location: Bald Hills Qld
Posts: 338
Default

Thanks everyone.....I'll post the results after I find the problem tomorrow;-)
kcej is offline   Reply With Quote Multi-Quote with this Post
Reply

Thread Tools
Display Modes

Forum Jump


All times are GMT +11. The time now is 08:31 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL