|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
08-09-2008, 07:40 PM
|
#1 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 8
|
G'day guys,
I have had a look around for a couple of engine mounts for my 75 TD Cortina with no luck. I was wondering if anybody else has sourced some from somewhere?? Had a look on rare spares website and they don't even have them..... Engine is a 4.1 X-flow. Any help would be greatly appreciated. Cheers, Cortina Fever. |
||
|
|
|
20-09-2008, 09:16 AM
|
#2 | ||
|
Regular Member
Join Date: Jan 2006
Posts: 181
|
which part of the mount do you need
|
||
|
|
|
|
20-09-2008, 04:26 PM
|
#3 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 8
|
Just the rubber for it.
I have found polyeurethane replacements, but they arn't suitable due to the heat coming from the extractors.. I need the original rubbers... Cheers Cortina Fever.. |
||
|
|
|
|
23-09-2008, 05:01 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Canberra region
Posts: 775
|
Can't you just shield them? a bit of sheet steel sandwiched between the mount rubber and the engine bracket and bent to suit should fix your problem permanently.
Urethane mounts may melt but rubber ones will turn to powder from the heat. |
||
|
|
|
|
23-09-2008, 05:17 PM
|
#5 | ||
|
Starter Motor
Join Date: Sep 2006
Posts: 8
|
I suppose you could shield them but it is more stuffing around.
My rubber mounts has cracked, it seems the heat has not affected it. Cheers, Cortina fever |
||
|
|
|
|
23-09-2008, 05:21 PM
|
#6 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Canberra region
Posts: 775
|
Mine turned to something resembling coal on my old XE after I fitted extractors to it.
I had to make a shield to protect the starter motor and another to protect the RH inner tie rod end as it melted and became very loose. I never noticed the engine mount until after the car got written off. |
||
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
TD 250 X-Flow engine mounts??
Linear Mode
