Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 26-10-2009, 09:52 PM   #1
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default Please help, before i kill my car!!!

A little back ground first. my car is an AU2 5L dual fuel Fairlane. i have owned the car for 4 years and 100.000 k's. when i bought it i did the plugs/leads ect it has never missed a beat on petrol or gas in that time.

fast forward to 3 weeks ago, lpg converter failed. booked it in for next week. gas guy asked to make sure car was running right on petrol. so i thought it was about time for some plugs and stuff. asked what plugs he thought were best, NGK BPR6EFS was the answer. i took out my plugs, they were just about stuffed, they were BPR5EFS-13. and now it all went south!!!!!! Put in the new plugs, car wouldnt idle, drove fine but wouldnt idle. put a post in the lpg forum and general thought was 0.8 gap was too small, rang gas guy, he said try 1mm gap. did that idle better but still lower than should be, reset ecu, now idle rising and falling. rang gas guy, go to 1.1 gap. at this point i checked the gap on my old plugs allowing for wear, about 1.1

so set the gap at 1.1 idle better but still too low but steady, took it for drive idle now rising and falling again. so one minute i have a car that runs smooth as, i change the plugs and it does this!!!!! so is it the lower heat range,6, and the plugs are fouling at idle? or is it the gap? With the BPR5EFS-13 the car ran perfecty on gas and petrol. i checked the ics it seems ok but when i unplugged it nothing happened? could it have all of a sudden gone dead? before the new plugs went in the idle always ajusted itself when the air came on or i put it drive now nothing. i have checked all the vacum lines and anything else i might have bumped


please any idea's

amiers is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 10:02 PM   #2
GK
Walking with God
 
GK's Avatar
 
Join Date: Mar 2005
Location: Melbourne
Posts: 7,321
Tech Writer: Recognition for the technical writers of AFF - Issue reason: Writing tech articles 
Default

The new plugs are 1 heat range colder than the ones that were in there. Colder range plugs run better for gas, but not as good for petrol.

Go get the plugs like you had in there before and regap them to 0.8-0.9. That will give you the best of both worlds.

GK
__________________
2009 Mondeo Zetec TDCi - Moondust Silver

2015 Kia Sorento Platinum - Snow White Pearl

2001 Ducati Monster 900Sie - Red

Now gone!
1999 AU1 Futura Wagon - Sparkling Burgundy
On LPG



Want a Full Life? John 10:10
GK is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 10:12 PM   #3
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

the thing that gets me is that the more i gap the plugs the better it idles and why isnt the idle ajusting itself like it did ?
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 10:47 PM   #4
bodes-sh
FF.Com.Au Hardcore
 
Join Date: May 2006
Location: Perth, South
Posts: 3,064
Default

did you run through the relearn procedure when you reset the ecu? it should fix itself, although it may take a bit of driving to sort itself out
bodes-sh is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 10:53 PM   #5
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

yes every time i reset the plugs
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 10:57 PM   #6
bodes-sh
FF.Com.Au Hardcore
 
Join Date: May 2006
Location: Perth, South
Posts: 3,064
Default

how much have you driven it since you did the last reset? it might be worth cleaning out the isc as well just to make sure it is nice and clean
bodes-sh is offline   Reply With Quote Multi-Quote with this Post
Old 26-10-2009, 11:08 PM   #7
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

drove it for about 20k's after setting the gap at 1.1 i might go back to the right heat range, 5, and set the gap at 1.1 or 1.2 and see how it goes
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 01:40 PM   #8
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

ok, put the recommended plugs i the car BPR5ESF-13 and cleaned the ICS. at first it still idled too low, then for no reason it started to run as it always has. idle was perfect and drove like a dream, about 5k's into the drive it developed a miss got it home and the idle was back to low and surging. let it sit for a while running and it started to run ok again, gave it a few revs and then It went back to bad idle. pushed and prodded every connection in the engine bay but found nothing. however i did find the plastic line in the pic. it was under the heater tap, cannot see where it goes or if it goes anywhere.

im starting to think maybe a lead is playing up? the only thing i have done is put in the plugs, so could new plugs stuff up a spark lead? coil pack? im running out of idea's


P.S dont know if this could have anything to do with it. had to get a battery in a hurry and bought just a standard one it has been fine but in the last week it seems to go flat in about 2 days, when i drive the car it seems to charge but i wonder if the alternator is going? would this affect the car on idle?

Last edited by amiers; 28-10-2009 at 01:55 PM.
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 02:14 PM   #9
Erich
Regular Member
 
Join Date: Mar 2009
Location: Mt Compass, Adelaide
Posts: 180
Default

Battery shouldnt go flat that quick - get the charging system checked - should be charging about 13.7 to 14.1 volts

If the battery is NOT recommended for the car - yes. Cars these day need a suitable battery to run all the electronics, expects certain voltages at certain spots. The AutoElec can advise on that also
Erich is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 02:49 PM   #10
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

thanks ERICH, it is to suit a Ford v8 but not heavy duty. and i suppose up til now the car has run fine. but i will check it
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 03:16 PM   #11
Erich
Regular Member
 
Join Date: Mar 2009
Location: Mt Compass, Adelaide
Posts: 180
Default

I see she is a Fairlane as well so she would love to suck up all that voltage ;)

Cars these days are suseptable to voltage drops - not saying its a certain but if the battery was fully charged, it may have been ok for a bit then there may be a fault with the alternator not keeping up with the discharge. Auto electrician will be your friend here me thinks
Erich is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 03:46 PM   #12
FordACE
Fast Ford to the Future
 
FordACE's Avatar
 
Join Date: Dec 2004
Location: Brisbane
Posts: 2,493
Default

that little vacuum hose is probably the cuase of your problems. it sticks underneath a vacuum switch, I think it generally controlls the heater core in the car. could be wrong.
__________________
CURRENT RIDE - 2011 FG XR6T Nitro 6sp Manual with Luxury Pack, 19 Inch Varrstoen 2.2.2 Matte Black, Herrod Intake
OLD RIDE - oZeCruiser: 1994 ED Falcon Futura
FordACE is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 05:23 PM   #13
AMB
FF.Com.Au Hardcore
 
Join Date: Feb 2008
Location: Geelong, Victoria
Posts: 4,503
Technical Contributor: For members who share their technical expertise. - Issue reason: Always has a helpful answer in the technical sections, wether it's giving information on a simple diagnosis with a small issue, Helping someone fix their car if they are stuck on removing/installing something, or just need information on what works how. 
Default

The battery is really only there to start the car. Once its running, the alternator does all the work, supplying all the power. Heaps of power is needed, thats why the alternators these days are something like 150 Amp or more.
AMB is online now   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 08:13 PM   #14
The Monty
Just slidin'
 
The Monty's Avatar
 
Join Date: Sep 2005
Location: Brisvegas
Posts: 7,791
Default

Id say your whole problem is your battery, if its going flat. Its not getting enough time to let your ECU to relearn everything after a reset. You need at least 100km of normal driving to do this, and then, if it goes flat when you stop it, and it gets jumpstarted, youll need to go for another 100km.
Get a new battery, let it learn, and then tell us how it goes.
__________________
MD Mondeo - For the family
NP Pajero - For the adventure
The Monty is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 08:50 PM   #15
RG
Back to Le Frenchy
 
RG's Avatar
 
Join Date: Feb 2005
Location: Back home.....
Posts: 13,346
Default

That little hose is definitely a vacuum hose and will affect idle quality if disconnected.

Sounds to me like you have either a dodgy lead or more likely a stuffed coil pack. How many k's she done and have you ever replaced the coil packs & leads?
__________________
Quote:
Originally Posted by drew`SEVNT5
nah mate, aussie cars are the besterest and funnerest, nothing beats them, specially a poofy wrong wheel drive
07 Renault Sport Megane F1 Team R26 #1397
RG is offline   Reply With Quote Multi-Quote with this Post
Old 28-10-2009, 10:33 PM   #16
scrivens
quarter pane
 
scrivens's Avatar
 
Join Date: Mar 2008
Location: Walkerville SA
Posts: 43
Default

Had one of these a while back, petrol only, but similar problem. Turned out to be poor earthing. Wouldn't idle smoothly, lights flickered a tad at idle and so on. Everything checked out OK in the system (battery, alternator, plugs, coils etc) but a thread here yonks back put me on the right direction. Start with the main body earth and go from there. That line is a vacuum hose as others have pointed out and it will cause rough idling if not connected.
scrivens is offline   Reply With Quote Multi-Quote with this Post
Old 29-10-2009, 12:02 AM   #17
amiers
FF.Com.Au Hardcore
 
Join Date: Dec 2004
Location: Brisbane
Posts: 976
Default

thanks guys, update till now. drove car for about 50k's tonight. still idle's at about 400 rpm. miss is gone, but it seems to be surging under load. the battery now seems to have full charge. i think the problem there is i dont drive the car much i.e maybe once every 10 days and since this drama started last week it has been wound over a lot and not driven.

i have looked everywhere for where that hose goes and cant find a place.

the thing that still gets me is until i changed the plugs the car ran faultless.

i pulled each lead off one at a time and there was a drop in the motor, so i can assume there is spark to each plug. as i said before there was 10 min today when it ran perfect, then it went back i didnt touch anything it just ran perfect


as for the age of the leads, coilpack and o2's i have no idea. i have done 40,000 since i bought and i havent done them. HOWEVER as i said until i changed the plugs it ran so well you wouldnt even know it was running, so what changed? it also behaves differently every time i drive it
amiers is offline   Reply With Quote Multi-Quote with this Post
Old 29-10-2009, 12:58 AM   #18
FordFalconBF
2008 BF Futura
 
FordFalconBF's Avatar
 
Join Date: Sep 2005
Location: Adelaide, S.A.
Posts: 595
Default

I had a similar problem in My AU Fairlane.. turned out the coil pack was stuffed.. even changed over the leads (needed doing anyway) and the o2 sensor... Just bite the bullet and take is somewhere and get the to diagnose to fix it..
__________________
2008 BF Falcon Futura
2009 BF Falcon Wagon Dedicated LPG

Previous Cars:
2003 BA Falcon Wagon Dedicated LPG
1999 Ford Fairlane Ghia
XF Fairmont Ghia
Escort MK2 RS2000 Replica
FordFalconBF is offline   Reply With Quote Multi-Quote with this Post
Reply

Thread Tools
Display Modes

Forum Jump


All times are GMT +11. The time now is 03:33 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL