|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
23-08-2011, 12:42 PM
|
#1 | ||
|
Regular Member
Join Date: May 2011
Posts: 40
|
Hi everyone,
I need to replace my intake manifold gasket and have never done it before. At the same time I was going to take off the top section and give it a good clean. I was hoping someone might be able to help point me in the direction of a photo/tutorial of how to do it (and any surprises might jump out)? Also any advice would be very handy Cheers,
__________________
Chris ____________________ 01 AU III XR6 Venom Red Pacemaker 4499 with 200cpsi cat & 2 1/2' Sports exhaust SS Induction Kit |
||
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Intake manifold removal
Linear Mode
