|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-04-2007, 06:43 PM
|
#1 | ||
|
XR6 Madness
Join Date: Jul 2005
Location: Cairns
Posts: 515
|
Was getting a rumbling sound coming from the car when i was traveling at speeds from 40kph to 90kph. replaced front hubs 1000k's ago and also replace carrier bearings to rear axel at same time. Also replaced brake pads.
now is a deep scratching sound from 20kph through to 90kph. sounds fine at 100kph. Car has done 209000k's. Gearbox replaced at 185000k's and has been serviced ok. Any ideas come to mind?
__________________
BA XR6 na - K&N, F6 Intake, Red Back Zoorst,
Custom Tune, Underdrives, Paccie #4490's with 2 1/2 Magnaflow |
||
|
|
|
03-04-2007, 06:50 PM
|
#2 | ||
|
Miami Pilot
 
Join Date: Jan 2005
Location: ACT
Posts: 21,703
|
Is it high pitched, and coming from the rear? Could be the handbrake shoes dragging on the inside of the discs.
__________________
-----------------------------------------------------------------
The Hammer: FG GTE | 376rwkw | 1/4 mile 11.793 @ 119.75mph 1.733 60' (4408lb) 1 of 60 FG MK1 335 GTEs (1 of 118 FG Mk 1 & 2 335 GTEs). Mods: Tune, HSD/ShockWorks, black GT335 19” staggered replicas with 245 & 275/35/19 Michelin Pilot sport 5s Daily: BF2 Fairmont Ghia I6 ZF, machine face GT335 19” staggered Replicas with 245s and 275s, Bilsteins & Kings FPV 335 build stats: <click here> Ford Performance Club ACT |
||
|
|
|
|
03-04-2007, 07:47 PM
|
#3 | ||
|
XR6 Madness
Join Date: Jul 2005
Location: Cairns
Posts: 515
|
nah, is not high pitched but more of a deep scratching noise.
Thought it could be the handbrake but have used it while driving and noise hasn't changed. Do u think it could be a tail shaft problem? Noise is still there when at speed but in neutral. Auto box.
__________________
BA XR6 na - K&N, F6 Intake, Red Back Zoorst,
Custom Tune, Underdrives, Paccie #4490's with 2 1/2 Magnaflow |
||
|
|
|
|
03-04-2007, 09:47 PM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
perhaps you run over a chook recently and its caught under the car:dr_Evil:
|
||
|
|
|
|
04-04-2007, 05:57 AM
|
#5 | |||
|
Blown 5L coming
Join Date: Dec 2006
Location: Warwick, QLD
Posts: 1,997
|
tail shaft problem? you'd feel that more then hear it. is it straight line, cornering or both that you hear it the most? about where do you think its coming from? it is possible that it is the auto, possibly out of or low on oil. yes, that does happen :lookedat: perhaps a dodgy bearing/hub, but you would be able to tell as you would only hear it more as your cornering.
__________________
1995 EF Fairmont was stocko 6cyl with open single spin diff....NOW WITH XR8 ENGINE, DRIVELINE AND SUSPENSION!!!!! Maybe by the end of 2010 there may just be a blower as well ;) NEW CLUB FOR SUNSHINE COAST !! www.f-p-e.proboards.com Contact Col (au2sw) via PM or on MSN @ efmonty@hotmail.com Quote:
|
|||
|
|
|
enoying sound :/
Linear Mode
