Diameter of the rubber joiner on i6 intake piping

[private9]

Hi All,

Just wondering if anyone knows off the top of their head the diameter of the rubber joiner in the intake piping of a 6 cylinder?

I could just measure it, but thought I'd just check if anyone knew off the top of their head!

Thanks,

Justin.

[stiddy]

3inch.

[private9]

Originally Posted by stiddy

3inch.

Thanks mate, that was easy!

You reckon you'd call it a 90 degree bend there?

[schuldiner]

Originally Posted by private9

Thanks mate, that was easy!

You reckon you'd call it a 90 degree bend there?

not quite, when i was doing my intake pipe i tried to get rid of it but the bit that connect to the throttle body, if you look closely you will notice that it's on a bit of an angle so although the bend is 90 degrees the angle the pipe is cut on won't be at right angles to each other if that makes sense lol