|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
21-01-2009, 06:44 PM
|
#1 | ||
|
Starter Motor
Join Date: Jul 2007
Posts: 8
|
Hi guys,
Just a quick question, i have just bought an 84 telstar and there are a couple of things that need to be done. Could anyone explain how to replace the idler bearing and the rocker cover gasket on an 84 Telstar? Bearing in mind that this will be the first time ive done this on any car.. Thanks FM |
||
|
|
|
21-01-2009, 07:56 PM
|
#2 | ||
|
290v
Join Date: Feb 2007
Location: Adelaide
Posts: 1,219
|
go to the Library they sometimes have the greogorys workshop manuals they could have a Telstar/Laser book for you to read better still ring them might save a trip
__________________
BA GT 2003 Silhouette 4 Speed Auto |
||
|
|
|
|
22-01-2009, 10:30 PM
|
#3 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
rocker cover gasket .take off the air filter
pop off the plug leads undo the bolts holding on the rocker cover (there are 7) lift off the cover use permatex blue or black to seal the new gasket and prevent oil leakage Idler pully a guess because the repair manual is no a good guide!!! argh undo/slacken off the drive belts - the idler pully may have a through bolt or an adjuster set up undo the bolt/ s holding the idler pully in place spanners and sockets are metric 10 mm 12 mm 14 mm... should do the job ok
__________________
My car goes Brumm Brumm |
||
|
|
|
|
23-01-2009, 06:25 PM
|
#4 | ||
|
Starter Motor
Join Date: Jul 2007
Posts: 8
|
Thanks mate, ill give it a go tomorrow
|
||
|
|
|
|
14-02-2009, 04:48 PM
|
#5 | ||
|
Starter Motor
Join Date: Feb 2009
Posts: 1
|
Forget the permatex remark ... Gasket should be new and fitted DRY ... sealant applied onlt to the corners
Ask any tradesman the bad effects of putting silicone types sealants on neoprene gaskets |
||
|
|
|
Help with 84 Telstar
Linear Mode
