Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Club and Speciality Forums > Forum Community Car Clubs > AU Falcon.com.au

Reply
 
Thread Tools Display Modes
Old 28-06-2010, 09:33 PM   #1
tickfrd6
Regular Member
 
Join Date: Aug 2009
Location: Melbourne, Gladstone Park
Posts: 489
Default Fuel filter?

Ok so I went and bought a new fuel filter aswell as oil and oil filter to service my car. I finised the oil change and all but when I went to change the fuel filter I couldn't find it. Looked everywhere in the engine bay but couldn't find it unless I'm blind.
Anyone know where it is?

Thanks
Matt

__________________
Au xr6: tickford kits, tickford 17s, momo T Bar and wheel, leather, lowered on ultra lows, 2.5" cat back with hot dog muffler, K&N panel filter and loving the car as a P plater

Future mods:
19" staggered wheels
Clear side indicaters.

That is all
tickfrd6 is offline   Reply With Quote Multi-Quote with this Post
Old 28-06-2010, 10:23 PM   #2
blueovalbits
Regular Member
 
blueovalbits's Avatar
 
Join Date: Jun 2010
Posts: 122
Default

The fuel filter isn't in your engine bay, it's underneath. Don't forget it is in a pressure line so to release pressure pull out your pump relay and try to start your car. This should let the pressure out. The filters themselves can be a pain to replace, mainly getting fittings undone.
blueovalbits is offline   Reply With Quote Multi-Quote with this Post
Old 28-06-2010, 10:51 PM   #3
AUIIPURSUIT
pursuit ute baby
 
AUIIPURSUIT's Avatar
 
Join Date: Jun 2010
Posts: 864
Default

look on the inside of the passenger chassis rail, behind the passenger seat, basically next to your trans. bit of a ***** of a job compared to the engine bay swap i was used to as well ;)
AUIIPURSUIT is offline   Reply With Quote Multi-Quote with this Post
Old 29-06-2010, 07:13 PM   #4
Auturbo6
The only thing u'll see!!
 
Auturbo6's Avatar
 
Join Date: Mar 2010
Location: Brisbane QLD
Posts: 498
Default

Fuel filter is located at the rear of the car, in front of the fuel tank. Will require good quality 14mm and 19mm spanners, and the other side has a quick release fitting. Simply grab the plastic fitting with 2 fingers on the cerated tabs on the fitting, push the whole fitting into the filter, push the tabs in and wiggle the fitting off. U must push the fitting towards the filter to release the tabs then pull of with a wiggling motion. Good luck
Auturbo6 is offline   Reply With Quote Multi-Quote with this Post
Old 29-06-2010, 08:55 PM   #5
aussiblue
FG XR6 Ute & Sedan
Donating Member3
 
Join Date: Oct 2006
Location: Bibra Lake WA
Posts: 23,492
Technical Contributor: For members who share their technical expertise. - Issue reason: Has been floating around the oze tech section for a long time and is always there to give advice when people have an issue. 
Default

Also read this tip from Ryco

http://www.rycofilters.com.au/librar...73_fitment.pdf
__________________
regards Blue
aussiblue is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 11:27 PM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL