|
|
OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
|
Thread Tools | Display Modes |
25-01-2006, 10:22 AM | #1 | ||
Regular Member
Join Date: Apr 2005
Posts: 60
|
just wondering if you guys have any suggestions as to why a head gasket would go after 20000kms since it was last done? worped head? job not done right the first time? bolt brocken? etc
Mind yu this is a car that does approx 400km a month. and 110k on the clock Can any on tell me what is the real cause for a head going? |
||
25-01-2006, 10:26 AM | #2 | ||
PM me if you want
Join Date: Dec 2004
Location: Pk Ranger Modding - QLD 👍
Posts: 7,498
|
block not cleaned propery.
head not skimmed before being put back on. head bolts not replaced. head bolts not torqued correctly. unlucky and a dodgy gasket. this time get head skimmed, check block is square and clean 100%, use NEW au headbolts, and AU head gasket, torque per au specs.
__________________
Owner of first ever car to retrofit BA SSS - the EA2BA Send me a PM if you want to know anything 2010 Ford Ranger PK High Rider (Auto) - 2011 Ford Fiesta (Auto)
|
||
25-01-2006, 10:30 AM | #3 | ||
Regular Member
Join Date: Apr 2005
Posts: 60
|
so the place i got it done in the first place didnt do there job right, i reckon.
|
||
25-01-2006, 10:44 AM | #4 | ||
PM me if you want
Join Date: Dec 2004
Location: Pk Ranger Modding - QLD 👍
Posts: 7,498
|
possibly is the case, but could just be a bad head gasket it does happen.
i would be willing to bet they did not get the head skimmed and thats why it went again.
__________________
Owner of first ever car to retrofit BA SSS - the EA2BA Send me a PM if you want to know anything 2010 Ford Ranger PK High Rider (Auto) - 2011 Ford Fiesta (Auto)
|
||