|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|
Thread Tools | Display Modes |
28-02-2017, 08:28 PM | #1 | ||
FF.Com.Au Hardcore
Join Date: Aug 2010
Location: NSW
Posts: 680
|
Hello all, hoping for some advice.
My 2001 NU V8 Fairlane Sportsman has developed a problem when under heavy acceleration. Anything more than about 2/3 throttle it breaks down (misfires/splutters) and seems to make a squealing noise from the engine similar to a belt slipping noise. I have recently replaced both tensioner adjustment pulleys and the serpentine belt as well as the coil packs. I disconnected the wire from the abs/tcs module today to see if it was that playing up however it still did it. I don't drive the car very often and only run it on 98 fuel. It still does it with fresh fuel. Any ideas would be appreciated. |
||
04-03-2017, 09:47 AM | #4 | ||
FF.Com.Au Hardcore
Join Date: Aug 2010
Location: NSW
Posts: 680
|
Thanks fellas,
The leads are good, no sparking. I'm going to have a good look at the harmonic balancer today to make sure its not cactus however I'd imagine if it was starting to move on the rubber I'd feel a vibration through the engine. It makes sense of what the squealing noise might be though. After that it's off to the mechanic for a test of the fuel pump and if that's all good I'll start looking at the cam sync sensor. |
||
04-03-2017, 03:10 PM | #6 | ||
5.6L x 2 pilot
Join Date: Dec 2009
Location: Canbra
Posts: 15,052
|
V8falcons is on the money. I have had a cam sync go before. It made the squealing noise you refer to. My symptoms were spluttering under any load. Each case is different I guess.
Cheers Stu
__________________
2002 AU II LTD 5.6L 342ci T3 Short, AFR165 heads, Comp XE270HR-12 Cam, Brembo 4/4s(355/330), T3 5 spokes, LC-1 wideband, Whiteline HD swaybars, TCE 3K Hi Stall, PWR Auto Trans Cooler, Koni shocks, King Low Springs, Hurricane headers, 100 cpsi cats, Twin 2.5" exhaust. Quarter Mile: 13.73 @ 105.86mph Runner Up NA/DA to BF Fairlane/LTD Geelong AFD 2024 2002 XR8 pursuit 250 Custom twin 2.5" exhaust w Herrod modifed extractors, Tuned with Moates QH
|
||
06-03-2017, 09:02 AM | #7 | ||
FF.Com.Au Hardcore
Join Date: Aug 2010
Location: NSW
Posts: 680
|
Thanks Stu,
The harmonic balancer looks fine, no wobble and I'm figuring if it was no good I would have a vibration. I ordered a Dorman cam synchroniser through Rock Auto in the US. For about $85 delivered I'll take a punt and replace mine and see how we go. |
||
This user likes this post: |