|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
 |
|
|
Thread Tools | Display Modes |
13-03-2006, 09:57 AM
|
#1 | ||
|
Regular Member
Join Date: Mar 2005
Posts: 102
|
Is there a simple temporary fix for a binding piston in the brake caliper? A fluid could be forced into the cylinder through the bleed nipple and flushed out again. Or RP7 somewhere?
Are there places in Sydney selling exchange calipers, maybe brake service outlets? Just did a forum search and it seems the problem could be the slides. Is that common? |
||
|
|
|
13-03-2006, 12:06 PM
|
#2 | ||
|
~~~
Join Date: Dec 2004
Location: At your U.B.
Posts: 2,099
|
It's more common for the slides to seize up.
|
||
|
|
|
|
14-03-2006, 10:01 AM
|
#3 | ||
|
Regular Member
Join Date: Mar 2005
Posts: 102
|
Simple fix
The guides being suspect, the rubber boots on the ends of the guides were lifted with a small screwdriver and RP7 sprayed onto the guides. Two screwdrivers were used to lever the outer pad slowly a couple of MM away from the disc. The brake pedal then pushed the pad back and that was repeated a few times. When the brakes were applied the wheel then turned freely. Should have done that years ago. It is not easy to juggle the wheel back onto the studs. Nearby was a garden spade, so I grabbed it and was surprised how easy it was to fit the wheel and also to remove a wheel. Could have been designed to remove and replace wheels. |
||
|
|
|
Brake Drag
Linear Mode
