|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-07-2020, 03:28 PM
|
#1 | ||
|
Regular Member
Join Date: Jul 2010
Posts: 83
|
this is the " non servicable " part of the heater hose from the mondeo.you can see the edge i sanded down on a 45degree angle , then used a knife the cut thru the rest of the plastic from the outer shell. u can see where there are some ribs to hold the hose, and i just used a clamp to tighten hose.. not bad fix for a few dollars instead of + $100
Last edited by krawczuk; 18-03-2023 at 02:29 PM. |
||
|
|
| 2 users like this post: |
|
03-07-2020, 03:53 PM
|
#2 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,519
|
Well done. Citroën had the same stupid idea in the late ‘90s for a lot of their low pressure hydraulic hoses and some heater hoses. You could skin the ends and fit new hose to the original fittings.
|
||
|
|
repaired " non servicable " heater hose fitting
Linear Mode
