|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
 |
|
|
Thread Tools | Display Modes |
12-04-2006, 08:36 AM
|
#31 | ||
|
Low and Loud
Join Date: Dec 2004
Location: Melbourne
Posts: 3,273
|
Nice Dig there :P
__________________
1993 Ford Fairlane NC3 Silver - LTD mockup, Worked V8 & Auto, Fully Optioned, Half of my Audio department at work installed in the car 1993 Ford Falcon XR6 Poly Green Stationwagon - 4.0 I6, Auto, 3:45LSD, All the usual XR6 Stuff but in a wagon  :
|
||
|
|
|
12-04-2006, 09:46 AM
|
#32 | |||
|
likes falcon's
Join Date: Jan 2005
Location: Melbourne
Posts: 6,091
|
Quote:
just forget the cost of the hose, just think of the savings of doing something more serious that would lead on from being a jew with a hose, cough headgasket 
__________________
www.carhubsales.com.au |
|||
|
|
|
|
12-04-2006, 12:32 PM
|
#33 | |||
|
Banned
Join Date: May 2005
Location: E-Suburbs of Melb
Posts: 2,814
|
Quote:
The leak is coming from under the passenger foot well just beside the fron left wheel, and only drips after ive been out the night before with the heater on. I just dont want to be stuck one night with no water. |
|||
|
|
|
|
12-04-2006, 01:24 PM
|
#34 | ||
|
likes falcon's
Join Date: Jan 2005
Location: Melbourne
Posts: 6,091
|
if u leave heater on will actually put less stress/pressure on that hose, that same one went on my car.
__________________
www.carhubsales.com.au |
||
|
|
|
|
12-04-2006, 05:06 PM
|
#35 | |||
|
OPT 20
Join Date: Mar 2006
Location: Country SA
Posts: 209
|
Quote:
__________________
'94 EF GLI Dash Mat Color-coded Ashtray Polished Wheel Nuts |
|||
|
|
|
|
13-04-2006, 09:48 AM
|
#36 | ||||
|
Donating Member
 
Join Date: Dec 2004
Location: Melbourne
Posts: 4,064
|
Quote:
My heater tap had a small crack in it. This allowed the leaking coolant to spray all over the inhibitor switch on the trans, causing it to fail and not select any gears on the way down Mt Dandenong one night :S
__________________
02 BA XR6 T U R B O Venom Red, Auto 13.97 @ 101mph Quote:
|
||||
|
|
|
|
14-04-2006, 12:51 PM
|
#37 | ||
|
Regular Member
Join Date: Dec 2005
Posts: 59
|
I had a leak in the same place as the thread starter on my EL.
There's the heater hose that goes into the back of the water pump. It just sits in there with an o ring, and a clamp on the metal pipe to the block holding it tight. It's easy just to undo the clamp, pull the pipe back 10mm, replace the o ring (oil it in vege oil first) and push it back in. You just have to be carefull to get it in even and not twisted. I did that 18 months ago and never had a leak there since. My first attempt still leaked, but I didn't get it sitting straight and hadn't oiled it. |
||
|
|
|
Linear Mode
