|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
15-11-2021, 08:14 AM
|
#1 | ||
|
Starter Motor
Join Date: Jul 2020
Posts: 1
|
I have a MSD Electronic Ignition distributer and MDS Blaster SS coil on my Windsor 408 V8. I am wondering if I need the MDS 8920 tach adapter kit to enable tacho to run properly. I have one of the reproduction 8,000 rpm tacho's to fit an XY GT dash. Any advice please would be greatly appreciated.
|
||
|
|
|
15-11-2021, 09:01 PM
|
#2 | ||
|
Donating Member
 Join Date: Dec 2004
Location: QLD
Posts: 11,836
 
|
I tried the tach adaptors for MSD to factory dashes in few different models , never really were very successful.
One was an XY ended up with ICE ignition because of the tach issue but the repro tach was a waste of time anyway |
||
|
|
|
MSD Electronic Ignition and Ford XY 8,000 rpm Tacho
Re: MSD Electronic Ignition and Ford XY 8,000 rpm Tacho
Linear Mode
