almost finished please help

syktlr · 28-06-2006, 01:18 PM

nearly finished my mpfi convert but a few questions,there is a small rubber pipe coming from the bottom of the inlet manifold on the motor side, where does that go?, does it go to the purge canister maybe and if so is i on the top or bottom.next question is the fuel lines does the inlet one go on the rail and the other on the purge canister(top or bottom).there is also a rubber pipe coming from the inside of the manifold next to the red pipe that goes under the left wheel arch.it goes towards the front where does that go?thanks

:

syktlr · 28-06-2006, 01:34 PM

ahh is the pipe near the red one go to the pcv valve on rocker cover

syktlr · 29-06-2006, 11:41 AM

help anyone

:

BLKPHN · 29-06-2006, 04:33 PM

um if it is the one that is towards the back of the manifold under it on the engine side on top of the air temp sensor that goes to the map sensor. the inlet for the fuel rail is a pipe that runs underneath the rail and the connects to the rail at the front the out let is where the furl pressure reg goes on to.

pic's would be a good idea mate.

tristan

syktlr · 29-06-2006, 05:14 PM

thanks mate lucky i asked, where does the breatherpipe from the back of the rocker cover go is it down onto the 3 piece white plastic on the manifold next to the firewall.

29-06-2006, 06:05 PM

Quote:

Originally Posted by syktlr

thanks mate lucky i asked, where does the breatherpipe from the back of the rocker cover go is it down onto the 3 piece white plastic on the manifold next to the firewall.

no, it goes to the throttle body.

syktlr · 29-06-2006, 06:35 PM

thanks for the help