|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
| View Poll Results: Bushes: Rubber or Urethane? | |||
| Rubber |
   
|
7 | 12.28% |
| Urethane (Nolathane) |
  
|
30 | 52.63% |
| Mix of both |
  
|
15 | 26.32% |
| Don't care, they don't make the car go faster! |
  
|
5 | 8.77% |
| Voters: 57. You may not vote on this poll | |||
 |
|
|
Thread Tools | Display Modes |
28-10-2005, 11:25 AM
|
#31 | ||
|
burn out king
Join Date: Dec 2004
Location: a.c.t
Posts: 341
|
about 2 years ago we took out cruiser to cape york before leaveing we put a set of urethane pushes in the front and a few months before that some rubber ones in the rear (cause thay were cheaper) on returning home the urethane was warn throu and the shackle pins were wearing on the chassie where as the rear one that were older were just as good as new and had to carry a load. it has greasable shackels on the front as well.
but for handleing urethane is hard to beat. |
||
|
|
Linear Mode
