|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
OzECruisers General Discussions E/N/D vehicles General Discussion ONLY. NO TECH THREADS |
|
Thread Tools | Display Modes |
06-02-2005, 07:07 PM | #1 | ||
Regular Member
Join Date: Jan 2005
Posts: 118
|
I need to measure the voltage of this to make sure it is fine, what there is two white wires and one black wire, wich wire (wires) do i use to test voltage? This should be around the 500mV mark shouldn't it?
Thanx very much. |
||
06-02-2005, 07:38 PM | #2 | ||
Chairman & Administrator
Join Date: Dec 2004
Location: 1975
Posts: 107,213
|
2 things to check.
Firstly the resistance should be 4.5 ohms at 20 degrees C measured across the heater wire elements. Voltage should be between 0.4 and 0.6. As wire colours change from model to model I can't help with whjich ones - on late models they are White/Grey and White/Yellow. Cheers Russ
__________________
Observatio Facta Rotae
|
||
06-02-2005, 08:26 PM | #3 | ||
Banned
Join Date: Dec 2004
Location: South East Melbourne
Posts: 6,156
|
From memory,
Black is earth One of the white is 12v for the heater The other white is O2 sensor current Make sure you measure voltage once the exhaust is hot. Make sure the voltage is oscillating. Last edited by Psycho Chicken; 06-02-2005 at 08:27 PM. |
||