|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
11-03-2022, 12:11 AM
|
#1 | ||
|
Starter Motor
Join Date: May 2020
Location: Perth
Posts: 14
|
Howdy, I have installed a LED lightbar behind the grille on my MD, but I need to get the switch wire from the engine bay into the interior to mount pon the dash (or under somewhere...
Does anyone know of a good place to get the wires through the firewall? |
||
|
|
|
11-03-2022, 03:17 AM
|
#2 | ||
|
Regular Member
Join Date: Feb 2016
Location: Goulburn NSW
Posts: 316
|
I ended up leaving the switch for mine under the bonnet, and just using a relay and high beam active to turn my driving lights on and off.
__________________
2012 MC Mondeo LX TDCi Wagon - Highway Hack 392K km and counting - Now gone 😢 2008 Peugeot 308 HDi - Highway Hack II 2008 Citroen C4 HDi - Highway Hack III 2010 Peugeot 308 HDi SW - Shaggin Wagon II 2016 VDJ200R Landcruiser GX Wagon - TTD V8 Power  !2017 Toyota RAV4 GX Wagon - Shopping trolley - Gone 2022 Volvo XC40 T4 Inscription - Shopping trolley II 2002 BMW R1150GS |
||
|
|
|
|
11-03-2022, 07:22 AM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Jul 2012
Posts: 3,878
|
There should be a wiring rubber grommet somewhere on the firewall that you can feed the wiring through bedside the existing wiring.If not drill a 5mm hole and put a dob of silastic on the wire to seal it
|
||
|
|
|
|
31-03-2022, 05:45 PM
|
#4 | |||
|
Starter Motor
Join Date: Apr 2010
Posts: 16
|
Quote:
 (If you are likely to tinker in the future, run some 5 or 7 core trailer wire - that way you only have to do it once and you have a few spare circuits for gauges and accessories) |
|||
|
|
|
| This user likes this post: |
|
01-04-2022, 04:35 PM
|
#6 | ||
|
Starter Motor
Join Date: Apr 2010
Posts: 16
|
Very neat!
Personally, as this is about as close as I'll ever get to an Aston Martin, I feel like 'round' is calling me:  (photoshop) |
||
|
|
|
| This user likes this post: |
Wiring from enginbe bay to cabin
Re: Wiring from enginbe bay to cabin
Linear Mode
