|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
04-05-2006, 06:52 AM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: May 2005
Location: In my shed
Posts: 5,066
|
I have a 96 Econovan cab chassis with a 3.1 x 1.8 x 1.8 box van on the back. This morning on the way to work I noticed the temp gauge reading a little higher than normal. When checking the radiator there was no water to be seen, next, I took off the oil filler cap and as I suspected, blown head gasket!.
To make matters worse, I only just replaced the head gasket and re-coed the head 4 months prior. I am now thinking, as the vehicle is slightly under powered (I usually only carry around 5-6 hundred kilos fully loaded and runs dual fuel with twin tanks) of doing an engine conversion, with the following options. 1. rebuild and turbo existing 2. V6 mazda 3. Telstar factory turbo engine (mid to late 80's) 4. 5ltr efi from E series to AU. 5. Holden V6 conv. If any one can point me in the right direction as far as conversions that have been carried out, problems, engineering, contacts etc. Your input would be greatly appreciated. Thanks, Mark. |
||
|
|
Engine conversion.
Linear Mode
