|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
21-03-2008, 12:57 PM
|
#1 | ||
|
1tuphute
Join Date: Mar 2007
Location: melbourne
Posts: 96
|
hi guys i no this is the wrong place but i kinda need help asap. im changing all the speakers in the car, and i need 2 take of the icc for amp reasons.
is it just the 4bolts and 1screw, then the 4 wire plugs to take off? it seems pretty jammed thanx guys, so 4 being in the wrong area |
||
|
|
21-03-2008, 01:12 PM
|
#2 | ||
|
1tuphute
Join Date: Mar 2007
Location: melbourne
Posts: 96
|
sorry guys i worked it out, can some one delete this thread,
sorry again guys |
||
|
|
|
21-03-2008, 01:13 PM
|
#3 | ||
|
Turbo Falcon Fiend
Join Date: May 2005
Location: Far West NSW
Posts: 3,213
|
OK - there are the 4 bolts (2 left and 2 right) There is the screw at the top under the cover.
You by now would realise there is also a need to take off the side panels that cover the bolts. I dont know if you realise but you also need to remove the lower compartment (just infront of the shifter) there are two screws either side, two pointng down, two going into the dash. Once that is gone, there are the 4 BEM plugs that have little clips on them. Once you have all that undone hold it at the top and bottom and pull it towards you and lift it slightly at the same time. It should come out - there is a plug at the back that is hard mounted both on the car and the ICC it slots in as the unit is seated. Remember to keep the unit upright as apparently tipping the unit upsets it somehow.
__________________
Just a few. |
||
|
|
need help guys, icc.
Linear Mode
