|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
12-08-2007, 09:57 AM
|
#1 | ||
|
Starter Motor
Join Date: Aug 2007
Posts: 1
|
I'm having issues with my 93 kh laser where the engine overheats, and i think it's because the fan is not kicking in. any suggestions on what to do?
|
||
|
|
|
12-08-2007, 09:57 PM
|
#2 | ||
|
Over Thinker
Join Date: Dec 2005
Location: Ipswich Qld
Posts: 1,351
|
get two wires running from the battery and direct test the fan
replace the resistor /check all the wirin connections fit a new thermostatic operation switch go to a wrecker and buy one that works
__________________
My car goes Brumm Brumm |
||
|
|
|
|
12-08-2007, 11:03 PM
|
#3 | ||
|
growing up is optional
Join Date: Feb 2006
Location: Gawler area SA
Posts: 3,303
|
Easiest way to check the fan is to unplug the thermo switch near the distributor. It will have a single wire going to it. The fan should run with the wire disconnected and the ignition on.
If it doesnt, you will have to look further for a wiring or fan motor fault. If it does, the wiring is fine and the thermo switch is stuffed. |
||
|
|
|
KH laser - fan not kicking in
Linear Mode
