![]() |
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 | ||
Donating Member
![]() Join Date: Oct 2006
Posts: 36
|
Hi,
Have a 2010 Focus LV and changed the coolant over the weekend. Undid the drain plug, and screwed it back in afterwards. Now there is a slow dribble from it. I'm guessing it is an o'ring that needs replacing. Can someone confirm and advise on how to remove the plug entirely. Thanks, James. |
||
![]() |
![]() ![]() |
![]() |
#2 | ||
Chairman & Administrator
![]() ![]() Join Date: Dec 2004
Location: 1975
Posts: 107,049
|
Hi James
There is no mention of an o-ring on the drain plug (I presume it's petrol) and the instructions for draining only say to undo it and then tighten it back up. Having said that, the picture of the part shows a rubber ring on the new plug and I believe it just screws all the way out.
__________________
Observatio Facta Rotae
|
||
![]() |
![]() ![]() |
![]() |
#3 | ||
FF.Com.Au Hardcore
Join Date: Mar 2013
Posts: 7,645
|
Genuine radiator plug looks like the below, part number 86AW 8115 AA. Does not look like there is a separate o ring?
https://www.kenyawebk.xyz/index.php?...ucts_id=655371 |
||
![]() |
![]() ![]() |
![]() |
#4 | ||
Donating Member
![]() Join Date: Oct 2006
Posts: 36
|
Thanks Russell and GTLEGEND,
The part GTLEGEND links to is the correct part. Unfortunately the local Repco didn't have one and Melbourne is in Lockdown. Was leaking too much to leave it for a while. So, need a screwdriver to lever it out as it is surrounded by a plastic tube, the barbs hold it in otherwise. I had a general plumbing repair washer kit from Burnings and one on the rubber washers was almost the correct size. Pull off old washer, press in new one and trim slightly around the edges. Fits Ok and seems to stop the leak - fingers crossed. Thanks, James. |
||
![]() |
![]() ![]() |
This user likes this post: |