|
05-04-2013, 08:15 PM | #1 | ||
Starter Motor
Join Date: Mar 2010
Posts: 15
|
I need help my 5.0 ute wont start just put in a starter motor was not that it just makes a clicking noise help me
|
||
05-04-2013, 08:50 PM | #2 | ||
Got Ghia?
Join Date: Jul 2006
Location: Perth
Posts: 999
|
Battery ok?
Got a multimeter? Check the battery voltage while cranking then Check for volt drop down the solenoid sw wire as you crank. (probe the sw terminal and a B+ source)
__________________
2007 BF MKII Ghia V8 - BA GT Exhaust| F6 Intake | Superlows | 19" GT-P's | 30mm Swaybar | - Sold 2002 AU2 XR8 Ute - Manual | Leather | Injected LPG | Pacemakers |
||
05-04-2013, 09:42 PM | #3 | ||
Starter Motor
Join Date: Mar 2010
Posts: 15
|
thanks it wont even crank over but it will clutch start tried two batterys
|
||
05-04-2013, 09:50 PM | #4 | ||
Rob
Join Date: Jan 2010
Location: VN Capital
Posts: 1,584
|
the ticking usually means flat battery.. make sure you do the terminals up tight too, just sitting them on there without doing them up won't start.
__________________
99 liquid silver AU Classic -Sold
Supercharged Nissan 350z 280rwkw Blueprint series 3 AU V8 manual |
||
05-04-2013, 10:07 PM | #5 | ||
Starter Motor
Join Date: Mar 2010
Posts: 15
|
yes all are tight I am lost I don't know what is wrong
|
||
05-04-2013, 10:11 PM | #6 | ||
Got Ghia?
Join Date: Jul 2006
Location: Perth
Posts: 999
|
Do you have a multimeter?
If not and you want to confirm it's not the starter (could still be the solenoid wire) look at the solenoid on the starter, there will be the thick B+ cable and another smaller wire attached to the plug on the solenoid. Disconnect this and jump a bit of wire from the b+ connection to this terminal on the solenoid and see if the started engages and cranks. Make sure you hand brake is on and it's not in gear!!!
__________________
2007 BF MKII Ghia V8 - BA GT Exhaust| F6 Intake | Superlows | 19" GT-P's | 30mm Swaybar | - Sold 2002 AU2 XR8 Ute - Manual | Leather | Injected LPG | Pacemakers |
||