|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
21-01-2008, 02:01 PM
|
#1 | ||
|
_Oo===oO_
Join Date: Dec 2004
Location: Australia
Posts: 3,305
|
I've got a small 'gash' on the bottom corner of my drivers door (caused by a power tool) the gash is about the width of a 5c piece and 1-2mm deep. I was wondering if anyone can give me some advice for fixing it (bogging it up?) and whether I could do that and then touch it up with some touch up paint. Is it a good idea to fix and paint it this way, or would I have to get a panel beater to fix the gash and spray paint the bottom half of the door.
   The damage area is pretty small but if you know its there its a real pain, as the bottom of the gash catches light and it really stands out. The paint is in excellent condition on the car so Id rather not get it re-painted if I dont have to. Any advice would be greatly appreciated! Cheers, Rob. |
||
|
|
|
21-01-2008, 02:06 PM
|
#2 | ||
|
Its Resonating!
Join Date: Jun 2006
Location: Sydney, NSW
Posts: 1,612
|
I would just wash it, then touch up paint it.
After all you can only keep cars that dont get driven spotless. |
||
|
|
|
|
21-01-2008, 02:12 PM
|
#3 | ||
|
_Oo===oO_
Join Date: Dec 2004
Location: Australia
Posts: 3,305
|
I went over it with some touch up paint, which did make a difference but Id like to fix it if theres a relatively simple way. If not I'll have to take it into the panel beater at some point.
Last edited by LeadFoot81; 21-01-2008 at 02:23 PM. |
||
|
|
|
Advice for minor fix and paint, drivers door AU
Linear Mode
