Welcome to the Australian Ford Forums forum.

You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today!

If you have any problems with the registration process or your account login, please contact us.

Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated.

Go Back   Australian Ford Forums > Ford Australia Vehicles > Small and Mid Sized Cars > Escort, Cortina, Sierra and Capri

Reply
 
Thread Tools Display Modes
Old 23-12-2012, 12:16 PM   #1
ZedGee
Regular Member
 
Join Date: Jul 2010
Posts: 70
Default MK2 Cortina Starting Problem.

G'day,

I need help, 1969 MK2 Cortina will not start. I know it's not rocket science, which is probably why I'm not a rocket scientist, but here's what I've done so far:

Replaced starter motor and solenoid, replaced all battery leads, additional chassis and battery earth connections installed, replaced auto trans inhibitor switch, checked and tested ignition switch.

I have tried two different batteries, results are the same. I have power where it's supposed to be going, but starter does nothing but click. Engine will not even turn over.

Is it possible the auto trans has jammed or something, not allowing the starter to engage with the flywheel or whatever?

Any advise would be greatly appreciated, I need this car going so I can take my Fairlane off the road for some TLC.

Cheers.

ZedGee is offline   Reply With Quote Multi-Quote with this Post
Old 23-12-2012, 05:04 PM   #2
wicko
Regular Member
 
wicko's Avatar
 
Join Date: Dec 2009
Posts: 53
Default Re: MK2 Cortina Starting Problem.

If it clicks it sounds like a connection problem - if the starter motor isn't cactus then it will be something simple so check and double check all connections.

I've had problems in the past where a connecting wire has come off the starter, also had loose negative earth on Battery.

Will it start using jumper leads ? or at least turn over with jumper leads?

When you said you replaced the starter motor was it a new starter motor or a 2nd hand 'spare' sitting on the shelf. Reality is if its a spare it could be as bad as the one you took off.
wicko is offline   Reply With Quote Multi-Quote with this Post
Old 23-12-2012, 05:36 PM   #3
ZedGee
Regular Member
 
Join Date: Jul 2010
Posts: 70
Default Re: MK2 Cortina Starting Problem.

Quote:
Originally Posted by wicko View Post
If it clicks it sounds like a connection problem - if the starter motor isn't cactus then it will be something simple so check and double check all connections.

I've had problems in the past where a connecting wire has come off the starter, also had loose negative earth on Battery.

Will it start using jumper leads ? or at least turn over with jumper leads?

When you said you replaced the starter motor was it a new starter motor or a 2nd hand 'spare' sitting on the shelf. Reality is if its a spare it could be as bad as the one you took off.
Every connection has been checked numerous times, all have been cleaned and rubbed with emery paper to ensure solid contact with battery terminals, engine and chassis, solenoid and starter.

Admittedly, the 'new' starter came off another MK2, which was last started a few months ago.

Car isn't in a position to jump start, but I hooked up another fully charged battery from my ZG Fairlane, result was the same.

I suppose I'll have to ditch the Lucas starter motor in favour of whatever is available...or buy another car!
ZedGee is offline   Reply With Quote Multi-Quote with this Post
Old 23-12-2012, 07:06 PM   #4
LG17
FF.Com.Au Hardcore
 
LG17's Avatar
 
Join Date: Apr 2012
Location: Taromeo
Posts: 10,625
Default Re: MK2 Cortina Starting Problem.

Did you check to see if the starter worked before you put it in?
As in not under any load.
LG17 is offline   Reply With Quote Multi-Quote with this Post
Old 23-12-2012, 07:47 PM   #5
wicko
Regular Member
 
wicko's Avatar
 
Join Date: Dec 2009
Posts: 53
Default Re: MK2 Cortina Starting Problem.

Try shorting the starter with a long screw driver - if it still does the same then its probably a stuffed starter (you did say it was a Lucas).

Let me know if your getting rid of the car - I'd like a Mk 2
__________________
There are people who makes things happen, those who watch what happened and those who have no idea what happened - which one are you?
wicko is offline   Reply With Quote Multi-Quote with this Post
Old 24-12-2012, 05:36 PM   #6
allanv6gt
Tippy-tronic Free Zone
 
Join Date: Dec 2008
Posts: 897
Default Re: MK2 Cortina Starting Problem.

Had a similar problem with a '76 Civic some years ago.
Turned out the starter solenoid (only) was cactus.
allanv6gt is offline   Reply With Quote Multi-Quote with this Post
Old 24-12-2012, 05:51 PM   #7
ZedGee
Regular Member
 
Join Date: Jul 2010
Posts: 70
Default Re: MK2 Cortina Starting Problem.

Much to the relief of my wallet, I got the thing going. I removed the starter, rotated the flywheel, re-installed starter and it fired first time. Seems like the starter motor pinion and flywheel were jammed or not disengaging properly.

Time for a new starter motor, just in case!
ZedGee is offline   Reply With Quote Multi-Quote with this Post
Old 24-12-2012, 06:00 PM   #8
allanv6gt
Tippy-tronic Free Zone
 
Join Date: Dec 2008
Posts: 897
Default Re: MK2 Cortina Starting Problem.

I removed the starter, rotated the flywheel, re-installed starter and it fired first time
or the teeth on the flywheel are non existent in that spot.....
allanv6gt is offline   Reply With Quote Multi-Quote with this Post
Old 25-05-2013, 04:55 PM   #9
TER2BO
REV8380
 
TER2BO's Avatar
 
Join Date: May 2013
Location: Hallam , Melb. VIC
Posts: 801
Default Re: MK2 Cortina Starting Problem.

Hi , yes there are some problems which can give grief .
1 the Lucas starter motors are getting long in the tooth and dont provide enough oomph
2. There are different number of teeth on some ring gears/Starter pinons
3. The pinon gear return spring is not working.
4 When the engine stops it returns to the same spot each time. This means that the starter is always working on the same part of the ring gear and it wears out.
But usually this will be hear by the starter werring and not engaging. Your problem is that the return mechanizm is jamming or the spring has had it. Sometimes it just needs abit of light oil and trying out of the car to make sure its doing what it should. Hope this helps if you have any further issues.
TER2BO is offline   Reply With Quote Multi-Quote with this Post
Old 27-05-2013, 05:51 PM   #10
ZedGee
Regular Member
 
Join Date: Jul 2010
Posts: 70
Default Re: MK2 Cortina Starting Problem.

Quote:
Originally Posted by TER2BO View Post
Hi , yes there are some problems which can give grief .
1 the Lucas starter motors are getting long in the tooth and dont provide enough oomph
2. There are different number of teeth on some ring gears/Starter pinons
3. The pinon gear return spring is not working.
4 When the engine stops it returns to the same spot each time. This means that the starter is always working on the same part of the ring gear and it wears out.
But usually this will be hear by the starter werring and not engaging. Your problem is that the return mechanizm is jamming or the spring has had it. Sometimes it just needs abit of light oil and trying out of the car to make sure its doing what it should. Hope this helps if you have any further issues.
Thanks for the information, as it turned out I had to replace the ring gear as the teeth were completely worn away on the transmission side. Inspecting the gear through the starter motor aperture led me to falsely believe all was sweet as the teeth looked intact. How wrong I was, how stupid did I feel and should have known better after 40 years working on many and various motors.

I guess I was clutching at straws in an attempt to avoid dropping the transmission, which I should've done in the first place. Laziness gets you nowhere.

Car now starts without any problems whatsoever, but I now have a jamming throttle linkage, which is pretty scary at full welly!!

Cheers.
ZedGee is offline   Reply With Quote Multi-Quote with this Post
Old 27-05-2013, 08:30 PM   #11
allanv6gt
Tippy-tronic Free Zone
 
Join Date: Dec 2008
Posts: 897
Default Re: MK2 Cortina Starting Problem.

as it turned out I had to replace the ring gear as the teeth were completely worn away on the transmission side.
I've seen this on my Capri ring gears, hence the suggestion.

At least you have tracked down the source of your problem.
Sometimes we look for the hard answers first (we're all guilty from time to time)
allanv6gt is offline   Reply With Quote Multi-Quote with this Post
Reply


Forum Jump


All times are GMT +11. The time now is 05:36 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Other than what is legally copyrighted by the respective owners, this site is copyright www.fordforums.com.au
Positive SSL