|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
03-08-2023, 01:39 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Apr 2009
Posts: 781
|
Hi,
Has anyone had occasion to remove this panel (either side) without damage to the fittings securing it to the car frame? If so I would appreciate some pointers as I want to run a power feed from a power brick fitted under the dash to a position adjacent to the drivers side of the rear view mirror. Thanks in advance for any replies. Cheers
__________________
AlanD  Our Drive: Mondeo MD TDCi Titanium Wagon Ruby Red |
||
|
|
|
03-08-2023, 01:59 PM
|
#2 | |||
|
Sprinting Everywhere!
Join Date: Jun 2012
Location: Sydney
Posts: 709
|
Quote:
|
|||
|
|
|
|
05-08-2023, 07:13 PM
|
#3 | ||
|
Challenge Accepted!
Join Date: Jan 2006
Location: Under the Southern Cross
Posts: 882
|
I started at the roof end, and it popped out then worked my way down the panel, tilting the top towards the passenger side, till the bottom curve could be pulled out.
__________________
Undecided replacement... [SOLD] -2009 MB Mondeo Zetec TDCI- [SOLD] |
||
|
|
|
| This user likes this post: |
MD A Pillar interior trim panel
Linear Mode
