|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
 |
|
|
Thread Tools | Display Modes |
10-01-2012, 11:16 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2010
Location: Sun City, North Australis
Posts: 4,274
|
Ok its kinda driving me nuts a bit, but my wagon has developed a noise which sounds like a worn bearing.
Car has only 130000, checked the front bearings and hubs were ok, no noise, but one spun slower then the other, so I decided to replace them anyways. No change. Up on hoist, spun rear tyres and its a bit noisy, bearin cup worn, replaced outer bearings, still make a bit of chatter (diff noise). Diff oils been replaced recently as well. Noise isnt very loud, but its noticable above 80kmh (but again not that loud). There is a balancer on the tailshaft, could it be this? Or worn uni's?
__________________
You've seen it, you've heard it and your still asking questions?? Don't write off the Goose until you see the box going into the hole.... |
||
|
|
|
11-01-2012, 12:00 AM
|
#2 | ||
|
When in doubt, GAS IT!!
Join Date: Sep 2006
Location: Lower Eyre Peninsula, SA
Posts: 3,018
|
What sort of tyres are on the car and how many kms are on them? Cheap chinese tyres, especially ones with chunky blocks on the shoulders tend to wear, especially the shoulders, not unlike a knobby on a dirt bike that's used on the road. They wear away the back of the block so eventually the shoulder has a serrated look about it. This causes the now mis-shapened block to "slap" onto the road instead of rolling onto the road thus causing excessive tyre noise. I had this happen with a nasty set of Triangle branded 17s' I stupidly put on the Fairlane last year. After 10,000km the tyre noise was very noticeable and it just got worse till it was horrid.
Bushbasher
__________________
. HERS- BFIII Wagon Gold, alloys, dual fuel, bullbar, big tow pack, trans cooler, fully rebuilt HD suspension, Clarion, alarmed, full 2 1/2" sports system, mint body MINE- AUII Forte Meteorite, dual fuel but otherwise bog stock. MINE- AUII Fairlane Sportsman Liquid Silver over meteorite,HIDs', Airhog, Eagle Leads, dual fuel, custom rear springs, BA slotted discs + a second one for spares . |
||
|
|
|
|
11-01-2012, 12:54 AM
|
#3 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2005
Location: Melb north
Posts: 12,025
|
maybe you could check Bushbashers tyre theory by swapping them front to back .
|
||
|
|
|
|
11-01-2012, 08:48 AM
|
#4 | ||
|
FF.Com.Au Hardcore
Join Date: Feb 2010
Location: Sun City, North Australis
Posts: 4,274
|
Yea i thought maybe it was road noise from them (havent swapped tyres front to rear). But depending on road surface I get a different tyre noise in the back ground, but the other noise is constant (ie doesnt change).
__________________
You've seen it, you've heard it and your still asking questions?? Don't write off the Goose until you see the box going into the hole.... |
||
|
|
|
AUII wagon wirrrr
Linear Mode
