|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
25-02-2019, 09:33 PM
|
#1 | ||
|
Lukeyson
 
Join Date: Mar 2005
Location: Maitland, NSW
Posts: 2,584
|
I just installed what I thought was a good set of used half shafts in a BA XR8. But after the install, I seem to have movement in an odd spot, and there's CV grease spitting out everywhere. Outer left half shaft.
Is this repairable? I suspect not, and that I have been sold a dud. The right side is fine. They were supposedly off a BF XR8 with 18,000km on it.  There's an IMG link right above this line that is just not appearing. https://photos.google.com/share/AF1Q...MwaGNWNURXOHZ3 Luke
__________________
If the human brain was simple enough to understand, we'd be too simple to understand it. |
||
|
|
|
25-02-2019, 10:02 PM
|
#2 | ||
|
DIY Tragic
Join Date: Apr 2018
Location: Sydney, more than not. I hate it.
Posts: 22,909
|
I've seen swaged-on caps like that on some Euro drive shafts, if they've not been correctly crimped on they jiggle and don't seal. assuming your CV feels OK and it's just the overcap motion you're worried about. Factory install used a three-curved-jaw chuck thing that pressed it into a slight depression all in one go.
Have had some joy with meticulous surface cleaning and then an oil-resistant gasket silicone pumped into the gap, but that's not a fix you'd sell to a customer as professional. |
||
|
|
|
Left Outer Half Shaft - Grease?
Linear Mode
